Fixed an issue for 2D contour in which the toolpath was not calculated using the check surfaces option.Fixed an issue where avoid surface clearance was causing an empty toolpath with unreachable passes.Added information to the log in cases where an adaptive toolpath fails to produce any path because the ramps are too large.Fixed an issue with rest shadow air cut reduction in pocket clearing that was not working correctly.Fixed an issue where a toopath did not reach all accessible areas when using holder protection (pull-away) in rest machining.Fixed an issue in which adaptive toolpaths that were trimmed by holder collision protection were not respecting the minimum cutting radius. ![]()
0 Comments
Leave a Reply. |